Electrical safety testing
Type tests to the IS and IEC series for appliances, luminaires, control gear and IT equipment — insulation resistance, dielectric strength, leakage current, earth continuity, abnormal operation and endurance.
Photometry & LM-79
Goniophotometer and integrating-sphere measurement of luminous flux, intensity distribution, efficacy, CCT, CRI and chromaticity, reported to IS 16106 and IES LM-79.
EMC, EMI & immunity
Conducted and radiated emissions, harmonics and flicker, plus ESD, EFT/burst, RF and voltage-dip immunity to the CISPR and IEC 61000 series.
Environmental & climatic
Damp heat, dry heat, cold, thermal cycling and combined exposure to the IEC 60068 series and MIL-STD 810 for accelerated life assessment.
Ingress protection & impact
IP and IK classification of enclosures to IS/IEC 60529 and IEC 62262 using dust chambers, water jets, immersion tanks and impact hammers.
Wireless & RF
Radio equipment testing against the ETSI EN 300 and EN 302 series for short range devices, 2.4 GHz systems and broadband wireless access.
EV charger testing
Conductive charging system evaluation to the IS 17017 / IEC 61851 series, covering AC and DC supply equipment and on-board charger EMC.
Compliance consultancy
Standard selection, pre-compliance screening, BIS and CE documentation support, and corrective-action guidance ahead of certification submission.
Scope at a glance
Standard families we work to
The complete list of 124 standards is on the testing facilities page, searchable by number or product.
- AppliancesIS 302 / IEC 60335 series
- LightingIS 10322 / IEC 60598, IS 16106, IES LM-79
- Control gearIS 15885 / IEC 61347, IS 16104 / IEC 62384
- SolarIS 14286 / IEC 61215, IS/IEC 61730, IEC 62109
- IT equipmentIS 13252 / IEC 60950-1, IEC 62368
- MedicalIS 13450 / IEC 60601 series
- SwitchgearIS/IEC 60947 series
- EMCCISPR 11 / 14 / 15 / 32, IEC 61000 series
- DefenceJSS series, MIL-STD 461 / 462 / 810
- EVIS 17017 / IEC 61851 series
Common questions
Before you send a sample
It depends on the standard. Safety and endurance sequences are destructive, so most luminaire jobs need three to five units. We confirm the exact count in the quotation.
Photometric and basic safety reports typically take five to seven working days. Endurance and environmental sequences run to the duration written into the standard, which can be several weeks.
Yes. You get the failing clause, the measured value and the limit. We can advise on the likely cause and retest the modified sample under the same conditions.
For installed systems and large assemblies, some tests can be performed at your site. Ask us during scoping and we will confirm what is feasible.
Reports are issued under our accreditation and recognition. Confirm the current recognition status for your specific scheme with us before applying.